Abstract

Natural gas transmission companies mark the right-of-way areas where pipelines are buried with warning signs to prevent accidental third-party damage. Nevertheless, pipelines are sometimes damaged by third-party construction equipment. A single incident can be devastating, causing death and millions of dollars of property loss. This damage would be prevented if potentially hazardous construction equipment could be detected, identified, and an alert given before the pipeline was damaged. The Gas Technology Institute (GTI) is developing a system to solve this problem by using an optical fiber as a distributed sensor and interrogating the fiber with a custom optical time domain reflectometer. Key issues are the ability to detect encroachment and the ability to discriminate among potentially hazardous and benign encroachments. The work continues on improving the signal-to-noise ratio of the technique. We are now able to detect weights sitting on the Hergalite fiber of as low as 0.2 pound. Detection of load fluctuations with frequencies greater than 1 Hertz is also possible. We have also purchased a brighter diode laser for use with the multimode fibers that should improve our sensitivity by a factor of ten. Document type: Report

Abstract

Ultrasonic guided waves (GW) due to their ability to monitor large areas with few sensors, are commonly employed for structural health monitoring (SHM) in aerospace, civil, and mechanical industries. The FBG sensors in the edge filtering setup are re-emerging as a favored technique for GW sensing. The FBG sensors offer embeddability, ability to be multiplexed, small size, and immunity to electric and magnetic fields. To enhance the sensitivity of these sensors, these sensors are deployed in the so-called remote bonding configuration where the optical fiber is bonded to the structure while the FBG sensor is free. This configuration not only enhances the sensitivity but also opens up possibility of self-referencing. In this setup the GW in the structure is coupled to the fiber and converted into fiber modes. These modes propagate along the fiber and then are sensed at the FBG. The conversion of the plate modes to fiber modes is a phenomenon which is still being studied. The effect of the adhesive layer and the material properties of the adhesive on the coupling are still not known. Furthermore the directional nature of this coupling and its marked difference from the directly bonded configuration needs to be studied in detail. For this detailed study a computationally efficient model which captures the physics of the coupling is necessary. Hence, in this research we develop a numerical model based on the spectral element method (SEM) for the modeling of the remote bonded configuration of the FBG. The model comprises four meters long optical fiber bonded to the center of the plate by the adhesive layer and the piezoelectric disc (PZT) used for wave excitation. The ability of the SEM model to capture the effect of the adhesive and the remote bonding as well as the directional nature of the coupling has been studied in this paper. The model is validated with analytical and experimental results. It has been shown that the SEM model captures the physics of the coupling and is computationally more efficient than other methods using conventional finite element software.