Dissolution Behaviour of Alkali-activated Fe-rich Non-ferrous Metallurgy Slag in Acetic Acid

Abstract

The application of Fe-rich non-ferrous metallurgy slag (NFS, within a FeOx-SiO2-Al2O3-CaO system) in alkali-activated materials requires detailed information on the durability performance. The present study investigates the durability of alkali activated NFS (AA-NFS) exposed to acetic acid to simulate the attack of a concrete by organic acids present in animal manure or sewage systems. The dissolution behavior of NFS and alkali-activated NFS (AA-NFS) was assessed by immersing NFS and AA-NFS in a 3 wt. % acetic acid solution at a liquid to solid weight ratio of 1000. The dissolved ions in the acetic solution from NFS and AA-NFS were measured at different time intervals over 7 days. Through the comparison of NFS with AA-NFS, the dissolution behavior of unreacted slag and binder in AA-NFS could be evaluated separately, considering a calculated amount of 47.7 wt.% of unreacted slag was present in the AA-NFS. The results demonstrated that the binder dissolves slightly faster than slag in the first 4 hours. Over half of the dissolution rate of the Ca, Fe and Al in AA-NFS was due to binder. While for Si, 41% total dissolution rate in AA-NFS was from binder and the other 59% was from unreacted slag. After 7 days however, the dissolved fraction of slag was higher than binder. About 90% Ca, 79% Fe and 71% Al in slag was ended up in the acetic acid solution, which is higher than that in binder (74%, 62% and 56%, respectively). A significantly higher difference was found for the total dissolved fraction of Si in slag (86%) compared to that in binder (43%). The highly connected silicate network in the binder remains largely intact as silica gel, while due to the low connectivity of the silicate species in the slag the silicate dissolves after the other elements have left the structure. Overall these results suggest that Ca has the lowest dissolution resistance in binder, followed by Fe, Al and Si.

Full Paper