Latest revision as of 12:29, 19 July 2016

Abstract

Plastic flow in crystal at micron-nano scales involves many new interesting issues. Some results are obtained for uniaxial compression experiments conducted on FCC single crystal micro-pillars, e.g. size effect and strain burst, etc. [1]. In these experiments, the surfaces are transmissible and loading gradients are absent. Therefore, the strain gradient theory could not well explain these new mechanical behaviors. This in turn has led to several hypotheses based on intuitive insights, classical theory and dislocation plasticity in order to study the size effect at submicron scale. In the model proposed [2], mobile dislocations may escape from the free surface leading to the state of dislocation starved whereby an increase in the applied stress is necessary to nucleate or activate new dislocation sources. By performing in-situ TEM [3], the dislocation motion affected the material properties is observed. However, the atypical plastic behavior at submicron scales cannot be effectively investigated by either traditional crystal plastic theory or large-scale molecule dynamics simulation.

Accordingly, the discrete dislocation dynamics (DDD) coupling with finite element method (FEM) [4], so a discrete-continuous crystal plastic model (DCM) is developed. Three kinds of plastic deformation mechanisms for the single crystal pillar at submicron scale are investigated. (1) Single arm dislocation source (SAS) controlled plastic flow. It is found that strain hardening is virtually absent due to continuous operation of stable SAS and weak dislocation interactions. When the dislocation density finally reaches stable value, a ratio between the stable SAS length and pillar diameter obeys a constant value. A theoretical model is developed to predict DDD simulation results and experimental data [5]. (2) Confined plasticity in coated micropillars. Based on the simulation results and stochastic distribution of SAS, a theoretical model is established to predict the upper and lower bounds of stress-strain curve in the coated micropillars [6]. (3) Dislocation starvation under low amplitude cyclic loading. This work argued that the dislocation junctions can be gradually destroyed during cyclic deformation, even when the cyclic peak stress is much lower than that required to break them under monotonic deformation. The cumulative irreversible slip is found to be the key factor of leading to junction destruction and promoting dislocation starvation under low amplitude cyclic loadings. Based on this mechanism, a proposed theoretical model successfully reproduces dislocation annihilation behavior observed experimentally for small pillar and dislocation accumulation behavior for large pillar. The predicted critical conditions of dislocation starvation agree well with the experimental data.

Recording of the presentation

General Information

• Location: Technical University of Catalonia (UPC), Barcelona, Spain.
• Date: 1 - 3 September 2015
• Secretariat: International Center for Numerical Methods in Engineering (CIMNE).

External Links

• Complas XIII Official Website of the Conference.
• CIMNE Multimedia Channel

References

[1] MD. Uchic, DM. Dimiduk, JN. Florando, WD. Nix, Sample dimensions influence strength and crystal plasticity, Science, 305(2004), 986-989.

[2] JR. Greer, WC. Oliver, WD. Nix, Size dependence of mechanical properties of gold at the micron scale in the absence of strain gradients, Acta Mater, 53(2005), 1821-1830

[3] ZW. Shan, RK. Mishra, SAS. ASIF, et al., Mechanical annealing and source-limited deformation in submicrometre-diameter Ni crystals, Nat Mater, 7(2008), 115-119

[4] ZL. Liu, XM. Liu, Z. Zhuang, XC. You, A multi-scale computational model of crystal plasticity at submicron-to-nanometer scales, Int. J. Plasticity, 25(2009), 1436-1455

[5] YN. Cui, P. Lin, ZL. Liu, Z. Zhuang, Theoretical and numerical investigations of single arm dislocation source controlled plastic flow in FCC micropillars, Int. J. Plasticity, 55(2014), 279- 292

[6] YN. Cui, ZL. Liu, Z. Zhuang, Theoretical and numerical investigations on confined plasticity in coated pillars at microscale, J. Mech. Phys. Solids, 76(2015), 127-143