(Created page with " == Abstract == The iBooster Gen2 is currently commercialized in three different motor versions: size1, size1+ and size2. Each motor size generates a maximum torque which cor...") |
m (Scipediacontent moved page Draft Content 895991843 to Villa Sabe 2020a) |
(No difference)
| |
Latest revision as of 09:03, 9 February 2021
Abstract
The iBooster Gen2 is currently commercialized in three different motor versions: size1, size1+ and size2. Each motor size generates a maximum torque which corresponds to a maximum support force required to slowdown the vehicle. In all these configurations the material of the Valve Body is PET50GF. The possibility of future size3 motors leads to a decrease of the system reliability below of the safety requirements. Therefore, the goal of this project is to identify a new plastic material for the Valve Body able to withstand the size 3 load collective of the iBooster Gen2 without changing the geometry of this part.
Original document
The different versions of the original document can be found in:
Document information
Published on 01/01/2020
Licence: CC BY-NC-SA license
Share this document
Keywords
claim authorship
Are you one of the authors of this document?