Research on Correction Method for Pipe-Soil p-y Curves in Submarine Silty Clay-Sand Gas Hydrate Formations


== Abstract ==

<p>The development of marine natural gas hydrates faces complex geomechanical challenges. Argillaceous silty hydrate reservoirs, due to their weak cementation and low permeability, have significantly different mechanical properties from those of general reservoirs. Based on the self-developed triaxial seepage experimental platform for hydrates, this paper systematically carried out triaxial compression experiments of argillaceous silt hydrate sediments, focusing on simulating the insitu temperature and pressure conditions of the formation, analyzing the influences of saturation, temperature and confining pressure on mechanical properties, and comparing them with the experimental results of sandy hydrate sediments. The experimental results show that due to the weak cementation effect of kaolin and methane hydrate, the failure mode of argillaceous silt hydrate is manifested as compression and dispersion, while sandy hydrate presents the traditional core compression failure characteristics. The peak strength of the stress-strain curve of argillaceous silt hydrate is lower than that of sandy hydrate, and the strain softening characteristic is more significant. The experimental results were calculated through MATLAB programming, and it was obtained that the cohesion and internal friction Angle of the argillaceous silt hydrate increased with saturation higher than those of the sandy hydrate. The pipe-soil coupling numerical simulation based on ABAQUS reveals that the initial stiffness and plastic deformation response of the p-y curve in the argillaceous silty hydrate formation are essentially different from those in the traditional API sandy soil model. By comparing the numerical simulation results of sandy properties and argillaceous silty hydrate, a two-parameter correction model for argillaceous silty strata was proposed. The cementation factor related to mass abundance and the displacement correction term were introduced. The error analysis indicated that the correction method was significantly superior to the API specification. Studies show that the mechanical properties of hydrates need to be evaluated independently, and the correction method provides a theoretical basis for the safety design of deep water well engineering.</p>



== Document ==
<pdf>Media:Draft_Sanchez Pinedo_640726017-5707-document.pdf</pdf>