Abstract

International audience; This paper deals with an energy management improvement based on frequency sharing approach for an electric vehicle. In order to satisfy the traction/propulsion system requirement, the Fuel cell (FC) system is assisted by lithium-ion batteries and Supercapacitors (SC). Bidirectional Buck Boost converters link the batteries and Supercapacitors to the DC-Bus. The FC stack is connected to the DC-Bus by an interleaved Boost DC-DC converter. The traction/propulsion motor is a permanent magnet synchronous motor (PMSM) coupled to a DC motor in order to emulate the vehicle's load and energy requirements during the driven cycle. The DC-Bus feeds the permanent magnet synchronous motor via a bidirectional DC-AC converter. The contribution of this study involves EV's energy effort sharing between Supercapacitors, Fuel cells and Lithium-ion batteries, taking into account the dynamic responses and electrical performances of each energy sources. The effectiveness of the control is verified through simulations performed on Matlab/Simulink software.

Abstract

International audience; This paper describes an energy management strategy for an electric vehicle (EV). The proposed EV architecture contains a pack of the batteries which presents the energy source and a pack of the supercapacitors (SC) used as power source. The pack of the batteries produces the necessary energy to move forward the vehicle while the pack of the SC produces the lacking power in acceleration and in braking phases. Two DC-DC converters are used to interface the energy sources with the DC-bus. A bidirectional DC-AC converter is used to connect the traction motor to the DC-bus. The proposed control method is focused on the power flow management within the EV depending on electrical behavior of the energy sources. The validity of the proposed control strategy is proofed through some reduced scale simulations tests using the New European Driving Cycle (NEDC).

Abstract

© The Institution of Engineering and Technology. One of the main problems in electric vehicles is the volume of their electrical systems because their bulky components carry additional mass and high cost to the total system. On this topic, interleaving-phases and magnetic coupling techniques have been reported as effective methods for increasing the power density of the DC-DC converters that work between the storage unit and the motor inverter. In that sense, a volume assessment of these topologies would provide a better understanding of the problems to be faced when an electric power train is designed. In this paper, a volume modelling methodology is introduced with the purpose of comparing four different DC-DC converters: Single-Phase Boost, Two-Phase Interleaved with non-coupled inductors, Loosely Coupled Inductor (LCI), and Integrated Winding Coupled Inductor (IWCI). The analysis considers the volume of magnetic components, power devices (conventional and next-generation), cooling devices and capacitors. The methodology can be used as a part of an optimization procedure to minimize the volume of DC-DC converters. Conclusively, LCI and IWCI were found effective to miniaturize power converters with a power density of 8.4 W/cc and 9.66 W/cc, respectively. Moreover, a maximum efficiency of 98.04% and 97.61% was obtained for a 1kW LCI and IWCI prototypes, respectively. ispartof: IET POWER ELECTRONICS vol:10 issue:14 pages:2010-2020 status: published