This report documents the second year's effort towards a 3-year program to develop micropilot ignition systems for existing pipeline compressor engines. In essence, all Phase II goals and objectives were met. We intend to proceed with the Phase III research plan, as set forth by the applicable Research Management Plan. The objective for Phase II was to further develop and optimize the micropilot ignition system for large bore, slow speed engines operating at low compression ratios. The primary elements of Micropilot Phase II were to evaluate the results for the 4-cylinder system prototype developed for Phase I, then optimize this system to demonstrate the technology's readiness for the field demonstration phase. In all, there were twelve (12) tasks defined and executed to support objectives in a stepwise fashion. Task-specific approaches and results are documented in this report. Research activities for Micropilot Phase II were conducted with the understanding that the efforts are expected to result in a commercial product to capture and disseminate the efficiency and environmental benefits of this new technology. Commercially-available fuel injection products were identified and applied to the program where appropriate. Modifications to existing engine components were kept to a minimum. This approach will minimize the overall time-to-market requirements, while meeting performance and cost criteria. The optimized four-cylinder system data demonstrated significant progress compared to Phase I results, as well as traditional spark ignition systems. An extensive testing program at the EECL using the GMV-4 test engine demonstrated that: (1) In general, the engine operated more stable fewer misfires and partial combustion events when using the 3-hole injectors compared to the 5-hole injectors used in Phase I. (2) The engine had, in general, a wider range of operation with the 3-hole injectors. Minimum operational boost levels were approximately 5''Hg lower and the minimum pilot quantity that the engine would operate on was roughly cut in half. (3) A successful concept demonstration of engine lube oil pilot injection was performed where the minimum operational boost was reduced by another 5''Hg to a boost level of 3''Hg; this is, depending on altitude, in the range of boost levels of many blower and piston scavenged low BMEP engines. (4) Micropilot ignition compares very favorably to other ignitions systems. The performance of micropilot ignition with mechanical gas admission valves is very similar to the performance of precombustion chamber ignition with high pressure fuel injection. Compared to spark ignition with mechanical gas admission valves the lean limit of operation is extended by about 5''Hg. These laboratory results will be enhanced, demonstrated and commercialized by others, with management and support from CSU, during Phase III of the Micropilot Ignition program.
Diff selection: Mark the radio boxes of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.
Published on 01/01/2004
Volume 2004, 2004DOI: 10.2172/825849Licence: CC BY-NC-SA license
Views 0Recommendations 0
Are you one of the authors of this document?